Cabinet Hardware Jig - How To Install Cabinet Handles and Knobs?

Install Cabinet Hardware Fast and Easy

A cabinet hardware jig is an adjustable tool designed to allow accurate, repeated drilling of cabinet handle and knob holes. A jig is commonly designed in a “T” shape with two intersecting rulers that allow for fast and infinite hole layouts on doors and drawers. These jigs feature steel guide bushings and locking screws for ease of use and durability.

Using a jig to install cabinet hardware is important because it not only gives you a pattern for hardware placement, but it gives you a straight hole to drill into your cabinet. If you’d rather buy one this cabinet hardware jig is kind of pricey, but when you think about how much cabinets cost, it’s well worth it. If you have a lot of cabinet hardware to install or different size hardware, this would probably be a wise choice.

A cabinet hardware jig is used by professionals to ensure drawers and doors have hardware holes in the right place. And from oversize drawers to basic shaker cabinet doors the best cabinet hardware jigs will ensure a knob or handle is properly placed. First, it’s tempting to free-hand cabinet knobs and handles. I know, I’ve done it.

1. Let's first figure out where all the screws we provide are used? We have 7 screws, including 2 small head screws and 5 large head screws. Two small head screws are used in the section of the longitudinal ruler, and five large head screws are used on the three position punch sliders and the longitudinal sliding panel. One of the position punch sliders is used as a sliding end stop. Two large screws are needed.

2. We put the horizontal ruler into the end of the longitudinal ruler, and indicate the marking on the longitudinal ruler at the middle of the horizontal ruler, and tighten the 2 small head screws to fix the longitudinal ruler and the horizontal ruler, as shown in the figure.

3. Put the longitudinal sliding panel from the other end of the longitudinal ruler. A big head screw needs to be installed on the side of the longitudinal sliding panel to fix the longitudinal sliding panel. This big head screw can be loosened at any time to facilitate the docking of the longitudinal sliding panel. Tighten this big head screw after the position.

4.3 Position punch sliders need to be the same as the longitudinal ruler, set on the horizontal ruler, and keep the punch hole on the position punch slider on a straight line, there is a position punch slider for the sliding end stop, this needs to be placed on the horizontal ruler one It can also be used for positioning on the outermost side. When in use, we first need to loosen the big head screw on the position punch slider. When the position punch slider is adjusted to the appropriate position on the horizontal ruler, we then tighten the big head screw to position the position punch slider on the horizontal ruler. position.

THE BEST CABINET HARDWARE JIG FOR DRAWERS AND DOORS (2022)

Woodworkers know that a cabinet hardware jig is a must to properly install cabinet hardware on doors and drawers. But the best cabinet hardware jigs will ensure both proper hole location and allow the user to quickly and easily setup and repeat holes without complex math.